Between Bonner and Potomac, MT - The Montana Department of Transportation (MDT) and Knife River Corporation has begun work to preserve the roadway on Montana Highway 200 (MT 200) east of the Bonner Interchange.
Work on about 3.5 miles along the Blackfoot River between Potomac and Bonner will continue next week. Weather permitting, milling and paving will take place from May 16 through May 19. This work is a more cost-effective approach to extend the life of the roadway. Work is also expected to take place during the first part of June when crews return to add chipseal to the area.
Travelers can expect some delays along with reduced speeds, and single lane traffic during construction. Traffic controls including additional signage and pilot cars will also be present. MDT encourages the public to be cautious at all times and leave additional time for travel.
Later this summer, additional work will be completed to preserve the roadway just north of the existing construction zone.
MDT wants everyone to remember the three S's of work zone safety: speed, space and stress. Slow down in work zones and follow speed limits. Leave enough room around your vehicle. Stay calm and pay attention to the road. Be prepared for delays, so before you leave, download MDT's mobile app "MDT 511" or visit mdt511.com and check your route. If you're driving and want to check in, pull safely off the road and dial 511. Tune in to local radio stations and watch for variable message signs along the route.
The public is encouraged to contact District Public Relations Specialist Megan Redmond at (406) 396-1978 with any questions or comments.
Alternative accessible formats of this document will be provided on request. Persons who need an alternative format should contact the Office of Civil Rights, Department of Transportation, 2701 Prospect Avenue, PO Box 201001, Helena, MT 59620. Telephone 406-444-5416 or Montana Relay Service at 711.
Reader Comments(0)